# nmcli con show
NAME UUID TYPE DEVICE
ens3f1 ad4de530-d769-41da-8106-492aa6935249 ethernet ens3f1
eno1np0 fdc36552-aa7f-4c55-b4d6-dabcf3c290b6 ethernet --
eno2np1 de2f6e48-7eb7-405b-9723-5chabad0d3b5 ethernet --
ens1f0np0 6cad5f98-2816-4cc9-bf93-98241e08b483 ethernet --
ens1f1np1 47224338-e98a-4051-b249-eeab9ff73d4a ethernet --
ens3f0 702fa45f-fe83-43e3-8f2e-738d1e54d0b2 ethernet --
Create the team interface (team0)
#nmcli con add type team con-name team0
Create the team slave and add in the group team0 as a master.
# nmcli con add type team-slave ifname ens1f0np0 master team0
# nmcli con add type team-slave ifname ens1f1np1 master team0# nmcli con show (To validate the team slave)
team-slave-ens1f0np0 d4938d49-a828-4c11-810b-59ae893f06f8 ethernet ens1f0np0
team-slave-ens1f1np1 8907f12b-1c16-4146-8f02-3724e9d89224 ethernet ens1f1np1
Add IpAddress
# nmcli con mod team0 ipv4.addresses 192.168.1.100/22Configure Gateway
# nmcli con mod team0 ipv4.gateway 192.168.1.1
Configure DNS
# nmcli con mod team0 ipv4.dns 8.8.8.8
# nmcli con mod team0 ipv4.dns 8.8.2.2
# nmcli con mod team0 ipv4.dns 8.8.2.2
Configure Manual mode
# nmcli con mod team0 ipv4.method manual
Configure autoconnect at startup
# nmcli con mod team0 connection.autoconnect yes
Restart the team0 (network service)
# nmcli connection down team0 && nmcli connection up team0
Check the status of your new interface.
# teamdctl nm-team state
setup:
runner: roundrobin
ports:
ens1f0np0
link watches:
link summary: up
instance[link_watch_0]:
name: ethtool
link: up
down count: 1
ens1f1np1
link watches:
link summary: up
instance[link_watch_0]:
name: ethtool
link: up
down count: 1
Available team modes
round-robin – data is transmitted over all ports in turn (default mode)
loadbalance – With active Tx load balancing and BPF-based Tx port selectors
lacp – implements the 802.3ad Link Aggregation Control Protocol
broadcast – data is transmitted over all ports
active-backup – one port or link is used while others are kept as a backup
